Home >

Waterbased Aliphatic Polyurethane
Waterbased Aliphatic Polyurethane
 
Alternative Views:




Container Size:


Qty:
Description Q & A
 
• Must be used in conjunction with our Non-Skid Additive
• Gives an attractive gloss finish
• Permanent
• Great for indoor/outdoor uses
• Non-yellowing
• High quality urethane, not epoxy
• Clear
• 1 gallon covers 175-275 Sq Ft
• 16 oz covers 23-27 Sq Ft


Water Based Aliphatic Polyurethane is a custom kit to be used in conjunction with our Non-Skid Additive. Designed to provide an extremely durable and permanent coating with the custom amount of slip resistance you choose. You decide how much and what type of additive you would like to use.

Made from the highest quality “non yellowing” components, this product can be used in almost any area to become the most slip resistant surface possible, in wet or dry conditions.

This is the same product used on airplane hanger floors and is ideal for high foot traffic, both indoors and out. It is waterproof and can be used on wood, concrete, tile, metal, garage floors, and just about anything else. The product can be lightly walked across in 24 hours, light commercial traffic can begin in 72 hours, full cure time is 3-5 days.

NOTE:
• This product is not for use on linoleum, laminate, or hardwood flooring.
• This is a permanent coating that is very hard to remove.
• This product does not contain any textured Non-Skid Additive. You must add Johnny Grip Non-Skid Additive to this product for your desired traction and texture.
How To Use
  • NOTE: This brief description is for illustration purposes only. Do not attempt to use this as directions. The full directions must be consulted before applying. The full directions are listed at http://www.slipperytile.com/print-wbu-directions

    1. PREPARE THE SURFACE

    2. PERFORM A TEST AREA

    3. MIX PRODUCT WITH NON SKID ADDITIVE

    4. APPLYING - Apply using a shed resistant 3/16”-3/8” nap mohair, or micro fiber cover with a phenolic core (do not use a cardboard core). Apply slowly to avoid air entrapment. Avoid lap/overlap marks, and work between logical break points to prevent lapping. Apply in thin coats at no more than 4 mils wet, or hazing may develop. Roll out all excess sealer from low spots, joints, and grout or pattern lines. Do not allow to puddle as hazing may develop. Do not coat any more then 4 mills thick, multiple thin coats are better then 1 thick coat.

Share your knowledge of this product. Be the first to write a review »
Copyright ©  Johnny Grip Products, INC.. All Rights Reserved.Built with Volusion