Home >

NON-SKID Paint/Sealer Additive - Plastic
NON-SKID Paint/Sealer Additive - Plastic
 
Alternative Views:


Our Price: $12.00



Container Size:


Qty:
Description Q & A
 
• Improves traction on wet and dry floors
• Made from recycled milk bottles
• Blends in with most surfaces
• Comfortable on bare feet (no sharp edges)
• Pours directly into any paint, sealer, epoxy, wax, etc.
• High or low traffic areas
• Surface cannot be mopped after coarse additive application
• Mixes into 1-gallon


Our exclusive plastic additive creates a safer surface on any interior or exterior floor. Manufactured from recycled plastic milk bottles, it will give your surface a durable, high-traction texture, wet or dry. Application only requires mixing the additive with the finish of your choice. The light weight of the granules enables them to stay suspended when mixed. This ensures a more uniform, even texture, resulting in a finish with no sharp edges that is ideal for bare feet around pools.
We have two sizes to best meet your needs:

1. Coarse - Our coarse additive has large granules and is recommended for outdoor use. Because of the large grain size, it is not suitable for mopping. The resulting surface can be pressure washed or scrubbed with a broom.

2. Fine - Our fine additive is half the diameter of the coarse additive and can be mopped. The fine grain size is better suited for indoor use and only provides a marginal traction increase.
How To Use
  • For most circumstances you should pour the additive directly into the finish. You can add up to 8 ounces (1 bag) per gallon, which is appropriate for most circumstances including walking ramps. But in the very rare cases where extreme traction is needed, an unlimited amount can be added when applying with our “Hand Shaker”. (Again very rare)

    DIRECTIONS: Pour the Non-Skid Additive into the medium while simultaneously stirring. Continue stirring until the additive is completely mixed. Be sure to stir the mixture every few minutes to keep additive from settling to the bottom.

    MIXING RATIOS:
    • 8 ounces of Non-Skid Additive (the whole bag) = 1 gallon of finish
    • 1 ounce of additive = 16 oz of finish
    • 2 Teaspoons of additive = 5 oz of finish
    NOTE: When poured directly into the finish, this product can be used at a maximum ratio of 8 ounces of additive per gallon of finish (ratio of half a part of additive for every 8 parts liquid).

    NOTE: If you would like to alter the texture you can fine-tune it by adding the Non-Skid Additive to the base coat only, or the top coat only, or both. You should first do a test sample to test results. We recommend you use the Non-Skid Additive in all coats. You must have a coat of finish over the additive to lock it down and prevent it from rolling away.

Share your knowledge of this product. Be the first to write a review »
Copyright ©  Johnny Grip Products, INC.. All Rights Reserved.Built with Volusion